
Sunroof wind deflector for BUICK ENCLAVE 2007 2008 2009 2010 2011 2012 2013 CLIP-ON Product Description:
- Clip-on sunroof wind deflector - Made in USA!
- No drilling or tape required - Hardware included
- Online installation video link: http://youtu.be/AtIz_LyIrS8
- Only fits model with an OEM factory-installed sunroof
- Easy to Install - Wind Deflector Installation Instructions 1. Open the sunroof 2. Place sunroof wind deflector in front of opening with curved side facing back. 3. Center deflector (If you can't determine the center, place a small piece of masking tape along sunroof front opening just out of the way and measure for center and mark it with a pencil, and also find the center of the deflector using the same method this will allow you to align for proper alignment for installation.) 4. TEMPORARILY tape the clips to the sunroof flange (lip or trim ring that you will find in OEM factory-installed sunroofs). 5. Put one screw thru the hole in the deflector and on into the hole in the top of the clip. You will have to exert quite a bit of pressure on the deflector to get the screw to feed thru the hole this is entirely normal. 6. Screw thumbnut from below and slowly tighten, allowing the open end of clip to clamp on lower edge of sunroof opening. 7. Repeat steps on other side, but you should tighten each side just a little as you go and keep deflector centered
Product Description
Benevento sunroof wind deflector designed to fit over factory installed sunroofs using 410 stainless clips, stainless screws, and thumb nylon nuts. No drilling required.
Customer Reviews
Most helpful customer reviews
0 of 0 people found the following review helpful.Quite but makes the sunroof smaller
By michelle velsmid
I got this wind deflector for my buick enclave. The wind deflector does a great job of cutting the wind noise. Traveling at 70mph with sunroof open and no noise. The reason that I didnt give it 5 stars is because it reduces the size of the sunroof by 21/2 inches, that doesnt sound like a lot but because this vehicle has a sky light in the 2nd row the front sunroof is already very small. The 21/2 inches lost from the wind deflector is extra space that sun could be shining through, roughly 25% of the sunroof gets shaded from the wind deflector. The installation was also a bit tricky and a 2 person job. You need a man on the inside of the vehicle to hook the piece of metal on the framing while a guy on the outside pushes down on the wind deflector so it flexs a bit. The screws seem a bit too short and its not easy to get the metal hooks to hook on. They give you plastic nuts and when you drop them in the inside of the track they can be tricky getting out especially because they are plastic and you cant use a magnet. I had to use a piece of duct tape to stick it to the nut in a tight spot that I couldnt get my fingers into. I good idea would be to lay a piece of tape sticky side up under the nut so that if it falls off it will get stuck on the tape.
Latest Price: See on Amazon.com!
More Info: See on Amazon.com!
See Customers Review: See on Amazon.com!
